H2O Sculpting Flash Baitfish Brush 5"

The Sculpting Flash Baitfish Brush makes it even easier to work with H2O's innovative Sculpting Fiber, which significantly reduces the tying time!

In just a few steps and with minimal use of materials, this Baitfish Brush can be used to create fishy patterns for fresh and saltwater in no time at all. The soft synthetic material is twisted with a stainless steel wire. Each strand is approximately 25cm long and the fibers extend roughly 6cm on each side of the center wire. You simply tie this strand in at one end and wrap it around the hook shank. For each twist, the material should be laid back to create a nice, even body. This works best with a brush or dubbing needle. Brush through completely at the end and the perfect body is ready to be shaped with scissors and then fished! Thanks to the long soft fibers, the H2O Sculpting Flash pulsates in the water with every strip of line and the discreet flash is just strong enough to catch the attention of hunting fish.

The applications of these brushes are very versatile:

• Bushy streamers for Pike, Zander, Perch, GT, Tarpon, etc.
• Articulated streamers in different sizes (for example with Wiggle Tails)
• Smaller baitfish imitations for Perch, Sea Trout, etc.
• Bristle worm imitations

 Details:

• Contents: 2 strands of approx. 25cm in length
• On average, 4 Pike streamer can be tied from one strand (8 streamers per pack)
• Fiber Length: approx. 6cm
• Total Width of the Strands: 12cm (5”)

Tip: The closer you lay the twists of material, the busier and more voluminous the body becomes. In our opinion, less is often more :)